Red Hat NETSCAPE MANAGEMENT SYSTEM 4.5 User Manual download pdf (Page 159)

Guest Operating Systems

159

www.vmware.com

5. Near the end of the installation, after files have been copied, you reach the

Monitor Setup screen. Choose Generic Standard VGA, 640x480 @ 60 Hz, then

click OK.

6. At the Video Memory screen, choose 256Kb, then click OK.

7. At the Clockchip Configuration screen, choose No Clockchip Setting

(recommended), which is the default, then click OK.

8. At the Probe for Clocks screen, click Skip.

9. At the Select Video Modes screen, don’t choose anything. Just click OK.

10. At the Starting X screen, click Skip.

Note: This is the most important step. Clicking OK runs the XFree86 version 4

server, which fails, and the installer aborts.

11. This completes basic installation of the Red Hat Linux 7.0 guest operating

system.

Note: We have occasionally observed an error message at the end of the Red

Hat 7.0 installation process — one that sounds serious but does not, in fact,

indicate a problem.

After your Red Hat 7.0 installation is completed and you click OK in the final

dialog to reboot the machine, you might see this message as the machine is

being shut down.

Install exited abnormally -- received signal 11

However, the Red Hat 7.0 installation has completed successfully, and the

operating system boots with no problems when you restart the virtual machine.

VMware Tools

Be sure to install VMware Tools in your guest operating system. For details, see

Installing VMware Tools and the Network Driver in the Guest Operating System on

page 73.

Note: With a Red Hat Linux 7.0 guest, you should install VMware Tools from the Linux

console. Do not start X until you have installed VMware Tools.

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 285 286

No comments

Red Hat NETSCAPE MANAGEMENT SYSTEM 4.5 User Manual Page 159