Red Hat NETSCAPE DIRECTORY SERVER 6.01 - DEPLOYMENT Installation Guide download pdf (Page 24)

Pramati Server 3.5 Installation & Configuration Guide

Verifying Server installation

1 Open the command prompt and go to the directory <install_dir>/server/bin.

2 Run runserver.bat.

3 This starts the Server and brings up the j2eeadmin@default:> prompt. This prompt is used for

performing Server administration and deployment tasks.

4 To shut down Server, type shutdown at the default prompt. The Server stops, and you return to

the command prompt.

Verifying installation of Deploy Tool

1 To verify installation of Deploy Tool, Pramati Server should be started.

2 Open a command prompt and go to the directory <install_dir>/server/bin.

3 If you are verifying a Deploy Tool installation, go to the directory <install_dir>/deploytool/bin.

4 Execute rundeploytool.bat at the command prompt.This opens the ‘Connect to Server’

dialog box.

5 Provide the following information:

• Server IP: Specify the Server IP or the host name where the server is running. For example,

127.0.0.1

• Naming Port: Specify the port on which the server is listening. For example, 9191

• User Name: Specify the username provided while configuring the realm. For the realm system,

the username is root

• Password: Specify the password provided while configuring the realm. For the realm system,

the password is pramati

• Realm: Specify the realm name. The default value is system

6 Click ‘Connect’ or press ‘<enter> to open the Deploy Tool.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 142 143

No comments

Red Hat NETSCAPE DIRECTORY SERVER 6.01 - DEPLOYMENT Installation Guide Page 24