Red Hat NETSCAPE DIRECTORY SERVER 6.01 - DEPLOYMENT Installation Guide download pdf (Page 49)

CHAPTER 11

Configuring Standalone Pramati Server Using Admin Service

Viewing details of added Standalone Server

To view the details of the added server, click its name that is provided as a link on the Home page.

This takes you to the ‘Home > Server’ screen showing the following details:

Configuring Standalone Server

To configure (verify or modify) the details for the added server, click on the configure button

provided. This takes you to the ‘Home > Standalone Node’ screen where you can modify details for

Lookup Port, HTTP Port, HTTPS Port and Enable HTTPS fields. Save the modifications made.

The Lookup Port and HTTP Port fields cannot be left blank.

The Standalone Server can be started from this page itself using the ‘Start’ button.

Note: You can modify Server properties only when the Server is not running. For further details on

configuring a Server using the Command Line, read ‘Managing Pramati Server Using Command Line’.

Starting Standalone Server

To start the Server:

1 You can either click ‘Start’

• against the required server on the Server Administration Service Home page, or

• on the ‘Home > Standalone Node’ screen used for configuring the Standalone Node.

2 The ‘Home > Server’, ‘Start Standalone Node '<name_of_server>' screen appears.

3 The fields Host, Lookup Port, and HTTP Port, on which the Web Container was started, cannot

be edited. These values are the same that were used while adding the server, and are displayed as

default.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 142 143

No comments

Red Hat NETSCAPE DIRECTORY SERVER 6.01 - DEPLOYMENT Installation Guide Page 49